What does rr htd mean in a fuse box
What does P WDW RH mean?
P/WDW RH. 25A. Power Window Main Switch, Rear Power Window Switch RH, Passenger Power Window Switch. HTD MIRR.
What is AM1 fuse?
The AM1 is one of the primary fuses that feed a lot of others, it’s going to be hard to figure out. The starter is not on it. With some research I found that the AM1 fuse is in a circuit with the starter, ignition switch and accessory. I looked at the starter first because it was the last repair.
What is Mir HTR fuse?
MIR-HTR 10 A: Outside rear viewmirror defogger. TURN 7.5 A: Turn signal lights, emergency flashers. ECU-IG 15 A: Cruise control system, electronically controlled automatic transmission system, anti-lock brake system, power steering system, retractable headlight system, power door lock system, power antenna.
What does STS stand for in a fuse box?
STS (Steering Switch) Front Right Power Window.
What is the AM2 fuse for?
The part that switches the gate to engage the starter. When you turn your car ON, the ignition switch is ON. Everything works. When you hit START the ign switch gate flips, and it starts drawing power from the AM2 circuit.
Which fuse is for tail lights?
The tail light fuse may be located in either the fuse panel in the front passenger side of your vehicle or in the main fuse box under the hood. Once you’ve opened either the panel or the main fuse box, locate the tail light fuse.
Where is brake light fuse?
Like all fuses, the brake light system fuse can be found in the power distribution center, which is under the dashboard or tucked away underneath the hood.
What is IGN fuse?
The ignition relay is usually found in the fuse box situated underneath the hood or somewhere under the car’s dashboard. It transfers electricity from the battery to the ignition components, which allows you to start the car in the blink of an eye.
Why do my tail lights work but not my brake lights?
The most common reason your brake lights are not working but tail lights do is a bad light bulb. It can also be caused by a blown fuse, bad brake light switch, or issues with the wirings. Your vehicle’s taillights are working fine, but the brake lights don’t come on when you press the brakes.
Are brake light and tail light the same bulb?
On many vehicles, the tail lights and brake lights share the same bulb. One filament inside the bulb is for the tail light and the other filament is for the brake light. There are also some vehicles that have a separate bulb for each circuit.
Why won’t my tail lights and dash lights work?
It could be that the dash and taillights share a common fuse. … So, if you do find a blown fuse, you’ll need to track down the reason it blew in the first place. Other potential causes for your problem include a short somewhere in the circuit or a faulty light switch.
How do you check a tail light fuse?
Once the fuse that controls your tail lights is identified, it can be tested using a fuse tester, which will light up if the fuse is good. If it doesn’t light up, the fuse should be replaced with one of the same size and amperage. On certain fuses, you can visually see a break in the metal wire inside a bad fuse.